CUSTOM SHEET METAL · MADE IN AMERICA

Custom Roof Curbs

Made to your dimensions, checked for manufacturability and prepared for fabrication.

Design Roof Curbs

Made-to-order roof curbs

A roof curb is a raised, boxed frame set on the roof deck that lifts a single piece of rooftop equipment — an RTU, exhaust fan, condensing unit or skylight — above the finished roof surface so the membrane can be flashed up and over the curb wall in one continuous, weathertight enclosure. PMX Flashing lets contractors, roofers and facility teams start from a proven profile, enter exact leg dimensions and bend angles, select a material and request fabrication review, so the curb is sized to the equipment footprint and roof pitch instead of forcing a stock size to fit.

Because a curb fully surrounds the equipment opening, every wall, corner and cap detail is part of one water-management assembly. Curb height above the finished roof, corner construction, cap slope and the transition to the roof membrane all influence long-term performance, and low- or no-slope roofs commonly call for a tapered or pitched curb so the mounted equipment sits level. The online designer creates a clear starting configuration; final manufacturability and project suitability are confirmed during review.

Available material choices may include galvanized steel, Galvalume, aluminum, stainless steel, copper and pre-finished steel. Curbs that will carry an insulated liner or thermal break need the extra depth accounted for before ordering, and exposed corners are usually seamed or gasketed rather than left as a simple bend. The right material depends on exposure, expected service life, appearance, contact with adjacent metals, coating requirements and project budget.

To measure a custom roof curb, record the equipment or opening footprint the curb must clear, the required curb height above the deck, and the roof slope at that location. Note which side is the high side on a sloped or tapered curb, where any factory curb or existing curb footprint must be matched for a retrofit, and where ductwork, conduit or piping must pass through a wall. Measure the existing opening in more than one direction, since roof decks are rarely perfectly square.

PMX fabricates custom sheet metal products for shipment to projects throughout the United States. Use the designer for pricing guidance and a dimensioned configuration, then request a fabrication quote. Production pricing, tolerances, lead time, packaging and freight are confirmed before the order is released.

Roof Curbs Types and Styles

Start with one of these common styles, then adjust every dimension for the project condition.

  • Standard Box Curb
  • Pitched / Tapered Curb
  • Insulated Equipment Curb
  • Adapter / Retrofit Curb

Roof curbs vs. roof equipment rails

A curb encloses a single piece of equipment on all four sides and ties into the membrane as one sealed unit. When the job is instead a linear run — piping, conduit, cable tray or a rooftop walkway that needs to be lifted clear of the membrane along its length — a roof equipment rail is usually the better fit, since it supports the load at a series of points rather than enclosing it. See Roof Equipment Rails for that configuration.

Ordering and installation planning

Confirm field dimensions and the direction of every bend before ordering. Installation methods must be selected for the substrate, exposure and governing project requirements. PMX supplies the fabricated sheet-metal component; the contractor remains responsible for final detailing, code compliance, waterproofing integration and installation.

Related Products