CUSTOM SHEET METAL · MADE IN AMERICA

Custom Roof Equipment Rails

Made to your dimensions, checked for manufacturability and prepared for fabrication.

Design Roof Equipment Rails

Made-to-order roof equipment rails

A roof equipment rail is an elevated, linear sheet-metal support — typically run in pairs — that lifts piping, conduit, cable tray, ductwork or a walkway clear of the roof membrane along its length, spreading the load across a series of support points instead of enclosing one piece of equipment on all four sides. PMX Flashing lets contractors, roofers and facility teams start from a proven profile, enter exact leg dimensions and bend angles, select a material and request fabrication review, so the rail is sized to the actual run length and support spacing instead of forcing a stock length to fit.

Typical applications include rooftop pipe racks, conduit and cable-tray runs, condenser and equipment pads, and elevated walkway or paver support. Because a rail is a support element rather than a sealed enclosure, base width, foot bearing area, tie-down spacing and compatibility with the roof membrane matter more than perimeter sealing. The online designer creates a clear starting configuration; final manufacturability and project suitability are confirmed during review.

Available material choices may include galvanized steel, Galvalume, aluminum, stainless steel, copper and pre-finished steel. Rails carrying a sustained structural span or concentrated point loads typically favor a heavier gauge or hot-dip galvanized steel, while aluminum is common where corrosion resistance matters more than load span. Gauge and maximum piece length also depend on the material and the profile geometry.

To measure a custom roof equipment rail, record the total run length, the spacing between support or bearing points, and the height the rail must hold above the membrane for the pipe, duct or walkway it will carry. Note the direction of the run, any turns or offsets, and where the rail must clear curbs, penetrations or adjacent equipment. Measure the full run rather than a single section, since roof decks and parapets are rarely perfectly straight.

PMX fabricates custom sheet metal products for shipment to projects throughout the United States. Use the designer for pricing guidance and a dimensioned configuration, then request a fabrication quote. Production pricing, tolerances, lead time, packaging and freight are confirmed before the order is released.

Roof Equipment Rails Types and Styles

Start with one of these common styles, then adjust every dimension for the project condition.

  • Paired Support Rail
  • Continuous Sleeper Rail
  • Walkway Support Rail
  • Pipe / Conduit Rack Rail

Roof equipment rails vs. roof curbs

A rail supports a linear run at a series of points and does not enclose what it carries. When the job is instead a single piece of equipment that needs a fully sealed, membrane-tied enclosure — an RTU, exhaust fan or skylight — a roof curb is usually the better fit, since it wraps the equipment opening on all four sides. See Roof Curbs for that configuration.

Ordering and installation planning

Confirm field dimensions and the direction of every bend before ordering. Installation methods must be selected for the substrate, exposure and governing project requirements. PMX supplies the fabricated sheet-metal component; the contractor remains responsible for final detailing, code compliance, waterproofing integration and installation.

Related Products