Made-to-order sill pans
Custom sill pans is most useful when an off-the-shelf profile cannot match the wall, roof, window or equipment detail in the field. PMX Flashing lets contractors, roofers, builders and facility teams start with a proven profile, enter exact leg dimensions and bend angles, select a material and request fabrication review. The result is a made-to-order sheet-metal component defined around the assembly instead of forcing the assembly to fit a stock part.
Typical applications include door and window openings where incidental water must be collected and directed outside. Every project should be evaluated as a complete water-management assembly. Dimensions, laps, end conditions, fasteners, sealants, membrane compatibility and drainage direction all influence performance. The online designer creates a clear starting configuration, while final manufacturability and project suitability are confirmed during review.
Available material choices may include galvanized steel, Galvalume, aluminum, stainless steel, copper and pre-finished steel. The right material depends on exposure, expected service life, appearance, contact with adjacent metals, coating requirements and project budget. Gauge and maximum piece length also depend on the material and profile geometry. Hems can stiffen exposed edges; kicks and drips can help release water; end dams can contain water at openings; and carefully selected bend angles can improve fit against sloped or irregular construction.
To measure custom sill pans, sketch the cross-section as it will be installed and number each straight leg in sequence. Record every leg dimension, every bend direction and each included angle. Note which face is exposed, which direction is up, and where water should drain. Measure more than one location on existing construction so variations are discovered before fabrication. For assemblies with corners, penetrations or end returns, identify any separately fabricated accessories required.
PMX fabricates custom sheet metal products for shipment to projects throughout the United States. Use the designer for pricing guidance and a dimensioned configuration, then request a fabrication quote. Production pricing, tolerances, lead time, packaging and freight are confirmed before the order is released.
Sill Pans Types and Styles
Start with one of these common styles, then adjust every dimension for the project condition.
- Three-Sided Pan
- End-Dam Pan
- Back-Dam Pan
- Sloped Sill Pan
Ordering and installation planning
Confirm field dimensions and the direction of every bend before ordering. Installation methods must be selected for the substrate, exposure and governing project requirements. PMX supplies the fabricated sheet-metal component; the contractor remains responsible for final detailing, code compliance, waterproofing integration and installation.