Start from exposure and service life
The first question is how exposed the finished part will be and how long it needs to last with no maintenance. Galvanized steel is a common, economical choice for concealed or moderately exposed work. Galvalume adds better long-term corrosion resistance for a similar cost. Aluminum resists corrosion well and is lighter to handle on site, which matters on long runs or overhead work. Stainless steel and copper cost more but hold up in demanding or highly visible applications and, in copper's case, are often chosen for the patina finish as much as the performance.
Check what the flashing will touch
Contact between dissimilar metals can cause galvanic corrosion, so the material choice has to account for what the flashing will touch, not just the roof or wall assembly in isolation. Copper flashing against galvanized steel fasteners, or aluminum flashing against masonry with certain sealants, are the kinds of combinations worth checking before ordering. When in doubt, matching the flashing material family to the adjacent metal, or isolating the two with a compatible underlayment, avoids a problem that only shows up years later.
Appearance and finish
Pre-finished steel is available in a range of factory colors and is a common choice when the flashing is visible and needs to match trim, panels or a specified color. Copper is chosen specifically for how it ages. Where the flashing sits and how visible it is should factor into the material decision as much as raw performance.
Gauge, length and shop capability
Available gauge and maximum piece length depend on the material and the profile geometry — a deep or multi-bend profile in a heavier gauge has different press-brake and shipping constraints than a shallow, thin-gauge profile. The online designer checks the selected material and gauge against developed width and bend feasibility as you configure a part, and final tolerances, lead time and freight are confirmed during fabrication review.
Where material choice matters most
Material selection is especially worth getting right on assemblies with a long service expectation or high visibility, such as chimney caps, parapet coping and counter flashing, where the part is both structural and permanently on display.