Hems: stiffening and safety at an exposed edge
A hem folds the raw edge of the sheet back on itself, which stiffens what would otherwise be a thin, easily bent edge and removes the sharp raw edge from an installed, exposed condition. Hems are common on the exposed leg of drip edge, counter flashing and coping details, anywhere a person, ladder or maintenance activity might contact the edge directly.
Kicks and drips: directing water away from the wall
A kick — a short return bent back and down at the outer edge of a leg — gives water a clean break point so it drops away from the wall or trim below instead of running back underneath it. This "drip" behavior is one of the most functionally important details on a flashing profile: without it, water can wick back along the underside of the metal and reach the assembly it was meant to protect. Profiles like drip edge, Z flashing and head flashing depend on a correctly placed kick to do their job.
End dams: containing water at the ends of a run
Where a flashing run terminates — at a step, a corner, a window jamb or the end of a wall — water can otherwise escape sideways off the end of the piece. An end dam is a formed upturn at that termination that contains water and directs it back into the field of the flashing instead of off the end. End dams are especially important on sill pans and window flashing, where a leak at the end of the pan can end up inside the wall assembly rather than outside it.
Bend angles and fit
Beyond the standard treatments, the included angle of each bend can be adjusted to improve fit against sloped, out-of-plumb or otherwise irregular existing construction. A bend that is a few degrees off from square is often the difference between a profile that seats tightly against the substrate and one that leaves a gap for water to find.
Specifying these on your order
Each of these treatments is a configuration choice in the PMX Flashing designer — edge treatment, kick, and end-dam requirements are entered alongside the leg dimensions and bend angles, and the design is checked for manufacturability before pricing. If a project needs an edge treatment not covered by the standard options, note it when requesting a fabrication quote.