Start with the cross-section, not the part name
Every flashing profile, no matter how it will be described later — a Z, an L, a counter flashing or a coping cap — is really a series of straight legs joined by bends. Before worrying about what to call it, sketch the cross-section exactly as it sits, or will sit, in the assembly: one continuous line from the first exposed edge to the last, numbered leg by leg in the order the sheet metal actually travels.
Six things to record for every leg
For each straight leg in the sketch, write down: the leg length, the direction of the bend at the end of that leg, and the included angle of that bend. Do this in sequence around the whole profile — most flashing details need between one and six legs, which is the same range the PMX online designer supports directly.
Alongside the leg dimensions, note which face of the metal will be exposed to view, which direction is up once it is installed, and where water is meant to drain. These three notes matter as much as the numbers: two profiles with identical leg lengths can behave completely differently in the wall or roof depending on which way they are oriented.
Measure the real condition, more than once
Existing construction is rarely perfectly consistent. Measure the opening or detail in more than one location — both ends of a run, or several points along a wall — so variation shows up before fabrication instead of after delivery. If the profile has corners, penetrations or end returns, identify those separately; they are usually fabricated as their own accessory piece rather than folded into the main run.
Turn the sketch into an order
Once the legs, angles and orientation are recorded, the same numbers go straight into the PMX Flashing designer: enter each leg and bend, choose a material and edge treatment, and the tool checks developed width and bend feasibility before pricing. Starting from a recognizable preset — such as Z Flashing, L Flashing or Counter Flashing — and adjusting the dimensions is usually faster than drawing a profile from a blank canvas, and it keeps the geometry inside shop capability from the start.